Good Day All,
For a while, I have been preparing my second (this time Parkhomov like) replication attempt.
So where I am now:
I have two C799 ceramics closed tubes 500 mm long and 16 mm outer diameter.
Look like this:
0,5 мм Kanthal A1 wire.
High Temperature Insulation Cement for Kanthal wire insulation
Ceramic Insulation Blanket for General reactor insulation.
Lithium hydride 100 grams. Could not purchase less ONLY 0,1 g will be used.
Nickel Powders from the Carbonyl Process. It is appears to become highly restricted in my country (Can purchase only with military approval). So I am semi Criminal now.
Halogen Lamp glass (hope it is really quartz glass) as a capsule as a fuel holder and heat transferring to avoid local overheat.
Two K-Type thermocouples in ceramics http://cdn.stpulscen.ru/system…oduct/004/297/721_big.jpg
Two Thermocouple Amplifier MAX31855http://www.adafruit.com/product/269
Two Solid State Relay for coil temperature control.
Arduino MEGA as a controller.
LabVIEW for Control and Logging.
Now I am at Controller Programming stage so I really could use some help with LabVIEW + Arduino configuration.
Will post some Photos soon but please take into account that I am slow in my replication project mainly because I am lazy person (fighting with this now)