If it was obvious [the data was fake]...why has nobody seen it in 2015?
They did see it! Everyone who looked at it saw that it was fake, including me.
FAKE DATA has to be explained for all the paraameters.
Say flow was fake, but was then a real flow? Not 1500kg/h
but say 10kg/, or not flow at all?
I estimate the real flow was probably around 430 kg/h, based on the temperature rise, input power, and likely pressure. That is 3 or 4 times lower than the numbers recorded for the flow meter. These were fake numbers, since they were the same every day for weeks, which is impossible.
On days when the machine was turned off, there was no flow at all, although it is recorded at 1500 kg/h. Obviously that too was fake. Even you will probably realize that when the machine is turned off, the flow rate is zero.
The pipes according to Jed were half full, what was the non-fake flow then?
The pipes under pressure from the heat exchanger with a slow flow were full. Pipes below the heat exchanger were open to the air, in the gravity return. They were partially empty. Look at any fountain and you will see how that works. The schematic from Rossi shows the flow meter was installed in the gravity return. You don't believe that, but that is what it shows.
Temperature was not 103 c but how much?
Probably around 103 deg C. It was under some pressure from the heat exchanger, so it was liquid water, not steam.
Since there was no steam, and the flow rate was far lower than recorded, there was no excess heat.