me356: Photos of AURA control unit
-
-
Yes. me356 is sitting in the room and is still fine tuning the setup. He's connected to the controller with his laptop.
They just discovered an electrical issue cause by one of the devices of the setup. So they try now to switch off one after another to find the problem.
So far there is no clear signal for excess heat. But the graphs look very different from what we have seen from other replicators.
These differences can be related to the use of a flow calorimeter and the heat loss lags.
We should give them some more hours to get everything fine tuned.
-
-
Quote
The experiment will be ended now.
18:16 - stopped logging.
We are going to take a day away in order to allow Me356 to make changes and tests. We will be back to run on Monday and pack up by Monday night.
-
its ac not dc, therefore the area under the sinewave is taken into account by using 70% or so to calculate the power...
-
What ?
.
If the current and voltage are out of phase (Angle not equal zero), then the power is less
Search for power factor on Wikipedia
-
If it is a an electronic controller you can't really tell. If resistive a bit strange since don't expect much reactance at 50/60Hz. Maybe this is output waveform from a controller at some higher freq where significant phase difference might be expected (P=VAcos phi?)? These V and A will normally be RMS.
Or maybe this is before a decent LPF (my suggestion) that would introduce a phase difference even on pure resistive load.
-
I guess the show is over for today. I wish them better luck for Monday. Time is short.
-
I guess the show is over for today. I wish them better luck for Monday. Time is short.
Actually, the no-show (of XH).
-
-
.
If the current and voltage are out of phase (Angle not equal zero), then the power is less
Search for power factor on Wikipedia
Oh dear "if", on resistive load cos(phi) is equal to 1 so this is the consumed power.
-
If it is a an electronic controller you can't really tell. If resistive a bit strange since don't expect much reactance at 50/60Hz. Maybe this is output waveform from a controller at some higher freq where significant phase difference might be expected (P=VAcos phi?)? These V and A will normally be RMS.
Or maybe this is before a decent LPF (my suggestion) that would introduce a phase difference even on pure resistive load.
I well know but until data are only these (give me any proof, not "maybe") cos(phi) is still 1. The second power meter becomes stuck, broken or what?
Anyway few simple questions:
1) what about the final result of this new test ?
2) this device works ? (Y or N)
3) an XE has been measured and demonstrated beyond any doubt ? (Y or N) -
@Henry - thus far it appears not to work. But don't worry, there are many excuses.
-
Both power meters seemed to agree on current, voltage and power, according to the data.
-
If any good comes of this, it will be that MFMP has shown themselves once again to be of the highest integrity and capability, and the LENR+ community who funded the effort should be commended for their support in pursuit of the truth.
-
I'll just take the opportunity at this point to inform visitors here that "LENR+" is not widely considered to be a thing separate from LENR; the only proponents I know for this view are Peter Gluck and IHFB; perhaps some ECW readers also embrace such a distinction. But not Piantelli, Celani, MFMP and others whose work might arguably be included under such a tendentious category.
(But I'm also grateful to MFMP's competent and continuing efforts to look into LENR.)
-
Quote
To me that reads like a flamebait attempt by another Czech-based user who often writes on LENR-Forum
I'm from Czechia too and I don't engage in such silly games. This is my first comment here regarding AURA replication after all.
-
-
IH Fanboy , I can do that as well: there is most assuredly, definitely not a distinctive LENR+ community! There's LENR researchers, and LENR hobbyists, and LENR watchers, and they're all looking at LENR (whatever one takes it to be, and without assuming it's a single thing).
But we digress from the topic of the thread.
-
Quote
There is most definitely not a distinctive LENR+ community
We cannot deny the fact, that for example A. Rossi skeptics are concentrated right here: at the ECW they would be banned.
CLICK HERE to contact us.