Preparing the pixie dust as a ballistic missile / wash float to clumps and re-crush. to fine but not micro dust.
A pre heat rotational magnetic feed to move the hematite "now with week magnetics after heating" into a spiral tightening upward cone.
To simulare this you would need a heat plate, a rotational collector that can also launch the newly heated partices. just to do the dust collection would be a cavity for the dust to fall in, use a heat base with a restricted inlet and a magnetic field to continue the tornadic rotation to keep the dust rising.
this plastic part as the void in a flat stone plate or clay - /melt out the [;astic and refill with mercury // high volt spark adjustable timing regulate the mercury's heat.
Beryllium Oxide caps after filling.
Same but its just a water pump for hematite. this is place over the heater to channel the dust. Stone/Clay/ ect.
At this point the hematite is hot and is being manipulated by a week magnetic field. To literally ignite the particle a magneton design could do it if its acks like silver in a common microwave
A common microwave magntron and cathode use magnets and the cath is design to shed electrons as the cathode heats and discharges in a rotation to fill the voids and create the wave leaving the antenna .
A new magnet field would need to be added on top of this flower to add muliple rotating magnetic within the flower, fields for each void to capture the wave and as they fill to capacity exit the same hole the hematite dust is moving through after being launched if this fllower was also atop the other parts.
For the rotaion field for the magntron, The same melt out plastic part insulated but impregnated above the flower magneton /again using mercury and a regulated spark discharge to control heat. At this point it would look like a acetylene torch spewing sparks up into the air.
entanglement within a magnetic field, As the particles can only handle so meny electron, collisions with each other and with a target can release energy? would you agree with this at this point?
as- put the last of this in here, to sustain this reaction the exit of the hematite is what feeds the magnetron. just attach the magnetron on top of the exit with the antennas down into the viod holes of the flower. A contstant self sustaining reaction until the dust looses its hydrogen. Providing it will be a sealed unit.
The Cathode for this is the path of the ignited dust in a rotating funnel.