Interesting decision to move the post above here but ok~
Thermite hematite Reactor test bed
-
-
Interesting decision to move the post above here but ok~
DnG,
It had nothing to do with Rossi that I could tell?...so I moved it here.
-
Understood, It was a nickname from long ago for the voltage hike from a plastic pipe reaction. Plasticvolt. I forget most don't know~
-
Topic.
Saw tooth adjusting electromagnetic / load change / wave change .. Field regulator
Construction casing is gypsum mix for water retention / heat dissipation
No proper mirror inserts in this shell
Fuels and mixtures absent.
Emitter area / high temp paint with copper dust "cheep mirroring" area isolators throughout this casing
An attempt to point out a moving cathode as waist/exit,
Video description
Copper wire over iron rod electromagnet to rotate the wave within the flower holes and hold it in place.
The flower trap
upper reaction area and a view of the hole alignment for the lower emitter
lower emitter and holding area for the fuel mix
bottom case
Focus point line and other passages undrilled.
Using a spark plug on the saw tooth charger to discharge to 0 should be easy with a home made saltwater capacitor.
Attach a microwave oven magnetron through the hole in the bottom plate as a pre starter
Sea water tank. The one way valve is a Chevy EGR valve to keep positive case pressure.
The tank is fiberglass over plaster of paris,
External Content youtu.beContent embedded from external sources will not be displayed without your consent.Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy. -
After the other video ..accelerator ect Adding in the missing magnetic under belly to the emitters 6 point
lenr-forum.com/attachment/7619/
Sweep and grab from the sawtooth
2/18
electromags if things get stuck, something to think about ~ jhuy
Want to Advertise or Sponsor LENR Forum?
CLICK HERE to contact us.
CLICK HERE to contact us.