What started me following this LENR forum was my experience working with a close friend who has a business selling and servicing industrial boiler room equipment. His main work is servicing the numerous safety controls on boilers.
My state operates the boiler safety division under the Labor Department. Elevator certificates, boiler licenses and numerous other inspections and licenses fall under Labor Department control.
Any industrial scale piece of new steam generating equipment couldn't be used without extensive regulatory documentation.
A workaround in my mind would be a LENR device that replaced the heating element in an existing approved pressure vessel.
If I was designing my LENR device I would want something I could screw into my residential hot water heater to replace the resistor heating element.
Something that could replace a 2000 watt element and only use 250 watts would be a game changer. No robotic factories needed unless used to make the replacement elements.