Posts by Seiber Troutman

The push and pull of a magnetic field, maybe it can be a suspension push-pull. holding an active reaction within it should be possible if its in a micro dust form. but I bet its bastered to build~

18" volcano sim.

A poor mans zinc, pennys are hard to sand down without holding them, I just added plaster of paris ~

If you feel like it feel free, if not, I understand.

Seems most are still trying to contain and control the environment of the reaction. attempting to hold the temperatures for use or holding the fuel as a rod. Maybe at some point they will attempt the reaction as a common sand blaster or home heating oil furnce with the reaction in a momentary magnetic suspension panttern. As a pass through ignition..its may help open the box~

Sorry if I must it but has any of the fuels tested used zinc dust within the bind, ?

err

If anyone sees a video of this work please post it. especially if its a bit easier to follow.

https://aip.scitation.org/doi/full/10.1063/1.4994057

I made attempts to get a safe place to monitor ect. you can imagine the results from such calls.

Hopping my attempt will not run for very long..a month away.

I would not look at it at face value but its a good tattetale.

https://link.springer.com/article/10.1007/s11837-008-0132-x

Just about there~

Its why I went with the clay salt hematite body for the cavity with the flower having the tunnels within the flower design. The hematite/hydrogen particles may fill the tunnels after the magnetron detonation.

Like using a inkjet printer replaces a common pencil, we all fell for that too. and still do.

If the event on Jupiter continues, maybe we will see the start of active volcanoes spewing ash, its almost like the planet is in a active state of terraforming~

interesting similarities in that studying these slides makes one wonder~

A common oven magnetron tuning can ignite siver at very low wattage, A retuned mag at a frequency for paired iron water particles would be interesting to see.

Most are using high votage and not tunned frequency microwave to bring the reaction to high state within the material , just imagine al the kids without their social media

• Because it has not happened. And if LENR experiments "scale," one could be designed large enough to produce enough power and energy to impress even very resistant skeptics who hold the key to funding sources. And as others pointed out, an LENR reactor with enough excess power would self run a very long time, which would convince essentially everyone.

you'r right about that Seven. The downfall may be the frequenies we use for communications and a few other things may be disturbed.

Sometimes it takes 50 years before anyone see it. The 37 or so that post in here and the time it takes to agree on anything may make the use of the internet just as bad as paper.

post or paper, if this is video- idea is helpfull to bring new ideas to the table, it may still take 50 years before attempting it. Put the idea to the test~

Any chance of the Fig sheet ?

Maybe this design is better as a Cutoff frequency tube.

My intention is to use a remote start mag so I dont need a working cathode mag within the body, I'm planning to Strip a table top microwave oven for parts and use the wave to penetrate a cavity or some other area to get the reaction separated form the starter. i can't think of a better way to know its running in its own. From what you can see, any ideas? where to add the starter wave?