Maybe washing with ion exchange resin defoulant water before initial assembly would help. it may have bin in the area at my first go around .
Seiber Troutman
Member
- Member since Oct 5th 2017
- Last Activity:
Posts by Seiber Troutman
-
-
-
The last of the baby,
parts I built years ago
the pre-heat lower bowl built the old way,needless to say it can be done on the stove and frying pan but I use what i found from past evidence .
building each part separately attempting alignment tabs for everything.so the 3D prints are not as they seem. "AS in wrong" deliberatly.
lots of work for the curious future builders.
hopefully not so much for the here and now~
Trout.
Cathodes https://www.sciencedirect.com/…cle/pii/S1385894717307866
in the microwave to cure.
-
looking at - dont know if it helps
-
OK, its best I quit , everything I relate is wrong...
The process your all working with sounds more intersing then mine but I know when to walk away.
for the record my first design was much more simple.
I built a chain stone grinder to get the hematite from the ore,
I removed the steel bits of chain with a magnet
I used a smaller stainless steel screen to remove the smaller dust and try to keep out the damged stainless screen from the grinder.
pulled the deep purple wet hematite "water float method" brackish, and mixed it with a bit of clay and high temp mortar into a ball and pushed it down to the desired cathode height.
with a plastic straw into the now pancake
with about 3/8" each filled area in the straw let them dry.
when they fell out i drop them into hot coat powder " I dont know what temp it was. and then the oven 450 or just see the glossy coat.-insulator'
sand down the ends and installed them in the body you see in my pics. " short lived"
At the time I was only concerned with spark continuity.
I will wait and see what you all come up with.
-
one more.. Is the styrene the same as styrene used as heat and mold -parts like this. for making air tite casings.?
-
-
Understood. I still have raw material from my first round of processing, I'll start with the books and try again.
-
I would.
https://www.alibaba.com/showroom/potassium-ferrate.html
can you pic from this page , so I know we are on the same material.
-
-
-
-
-
-
-
-
-
I would like to be shore I understand your idea H=G what your thinking is build a suction type magnetic root drawing dust particles through the center of an active event "like a excitonium " reaction. charging these particles and then using a upper electric field allowing them to collide ? Sound about right?
-
-