We are talking about this kit?
The heather current is a 15Khz PWM signal, and the mains of the power supply is switched off and on all the time (depends on the temperature).
You induce RF by the…
You can have a good 36V DC supply, but if you switch the current on and off every 2 seconds ( 2 second pid loop) you induce a lot of RF pulses (@ switch moment).
You can canceled them out by adding capacitors over the heater coil (capacitors do short…
You could see the off to on switching as a dirac pulse, and it contains all frequencies.
So basically it could activate deuterium in a constant magnetic field.
You can cancel this out by adding a few big capacitors for lower frequencies and a few…
And it is switched off and on all the time to control the temperature?
This switching does make a lot of RF pulses over a wide frequency range.
Maybe deuterium is activated by the larmor frequency, maybe worth to check!
I was just thinking.
The LION reactor is pre heated, the heating current is this DC or AC?
If it is DC you get a constant magnetic field, and maybe there deuterium could be RF frequency sensitive (larmor frequentie)
Maybe it is possible to…
I’m very interested in cold fusion, and did spend some time reading articles.
Most reactions are seen in high deuterium loaded lattices, and movements of the deuterium inside the lattice seems also be a key factor.
Basic you want to have high…