Max Nozin UA/RU SPECIALIST & MOD

Kyukyutto reactor.

I would like to put this in a new thread, but I can never remember how to start a new conversation. Anyway:


I made some revisions to the Mizuno paper:

https://www.lenr-canr.org/acrobat/MizunoTincreasede.pdf

Biggest changes:

p. 1.

Note: Readers have made…

Jokela I agree with most you say but what Feyni video has to do with it. The dude could not explain why two magnets attract each other yet alone the major principles of the universe.

Have you seen Miles Mathis work - everything is light there as well.

I stopped being interested on BLP at the third cycle of reinvention, several years ago. Mills is much more worried of keeping the money flowing than of launching a product to market. Perhaps he is right, but he has zilch proof.

I have a few problems with the report:

1). It's not clear what he did for calibration. Yes, he hand-waves that away by pointing towards the first paper. This is not sufficient for such monumental results. Did he build a second reactor and have it in…

(Quote)

Conclusions about scientific matters and technology claims should never be about "belief" and "faith." Rather and obviously, it should be about facts, evidence, and good reasoning. Mills has never produced any device which did not require a…

What is the point of proving of what and has been proven many times already. Every design is a departure from the previous one. I am concerned. Randy was and still is my favorite of all, but my faith is weakening.

INFORMATION: Even if this post is already inside the off-topic area of the LENR-Forum, after a long discussion, the LENR Forum team decided not to allow topics that are even more controversial than LENR - cold fusion and have the potential to damage the

…

(Quote from Shane D.)

sound like frother on espresso machine.

If rubbing technique is as simple as Japanese knife sharpening we have a problem here.

Hope Mitsubishi and Toyota will replicate this...

(Quote from Max Nozin)


Ah, ha. I had that on my list of questions but we never got around to it. I will find out and update the paper. I intend to add some details before the conference from the work now underway. I mentioned this: "We hope we can test…

JedRothwell it is by far is one of the most detailed recipe. Is it possible to add more details about palladium rubbing. All it says it has to be 'vigorous' and then refers to the fig.11 where only the final product is shown. What is the source of…

sam12 'fluff' ?! Welcome to the club!

It is nice to have a hands-on person not bothered with previous knowledge of why it CAN NOT be done to take a fresh look. We already have enough of 'qualified scientists' on editorial boards of magazines like Nature.

Much more active discussion on ECW.
But, for those who don’t go there often I have tested a couple items from the Omasa lab visit.

1) Successfully burned through a pure tungsten rod with a cheap oxy-propane torch (cannot possibly get as hot as the…

(Quote from RobertBryant)

From the abstract:'In
this stage both “excess heat”and “heat after death”was observed once. '
Do I need to bother treading past that?

(Quote from JedRothwell)

Back to back means that we has had event today. The next day we followed the protocol and we did get had. The following day we also followed the protocol and we got HAD event . And so on. One off event belongs to urban legends…

JedRothwell since you are an expert please help me find a report of more than a single back to back run of experiment showing significant heat after death event. Thanks.