LDM Member
- Member since Apr 29th 2017
- Reactions Received
- 284
- Points
- 2,214
- Profile Hits
- 1,718
-
LDM reacted with to Alan Smith’s post in the thread BLP update.
[…]
Is that your strong belief? -
LDM reacted with to Cydonia’s post in the thread BLP update.
Agree you can induce lattice stress between 2 layers deposited at different parameters.
[…] -
LDM replied to the thread BLP update.
[…]
You have several parameters which influence the level of doping
Gas flow
This is how much gas pases throught the reactor at a given time.
Yhis is normally regulated by mass flow controllers
Gas pressure
Some doping can be done at atmospheric pressures.
… -
LDM replied to the thread BLP update.
[…]
I don't know what you mean by "the receiver"
Processing silicon wafers is about changing the electrical characteristics of the silicon by doping.
This is done in successive steps.
The first step is applying a thin silicon-oxide layer.
Then photoresist is… -
LDM replied to the thread BLP update.
[…]
The EUV is used to project an UEV light pattern on an UEV sensitive photoresist on top of the chip.
It is not used to etch the chip. -
LDM replied to the thread The perpetual “is LENR even real” argument thread..
[…]
Applying the laws of thermodynamics I calculated a value of 4.95. Close -
LDM reacted with to Cydonia’s post in the thread The perpetual “is LENR even real” argument thread..
-
LDM replied to the thread The perpetual “is LENR even real” argument thread..
[…]
The calculations I showed on this forum showed that for inflated temperatures due to the use of wrong emissivities the result was 86.5% of input.
For the non inflated case the result was 101.6 % of input.
An additional check posted on this forum based… -
LDM replied to the thread The perpetual “is LENR even real” argument thread..
[…]
No that would not explain it since assuming wrong emissivities goes against what you calculate when applying the laws of thermodynamics..
That said, I admire all the work you are doing in documenting all the research on LENR.
Thanks for that ! -
LDM replied to the thread The perpetual “is LENR even real” argument thread..
[…]
I did not state that I had all data, but had enough to make an estimate -
LDM replied to the thread The perpetual “is LENR even real” argument thread..
[…]
I recently had the opportunity to look at the data of an experimenter which used a Rossi like process.
My estimate. based on that data was that there was a COP of at least10.
No need for precise calometry! -
LDM replied to the thread The perpetual “is LENR even real” argument thread..
Quote from @Jed :
No, this is not a "judgement call." It is a technical discussion. It must be grounded in the laws of physics and textbooks on calorimetry. No judgement is involved; only facts that have been firmly established for 150 years, and which… -
LDM replied to the thread NetIO GC10 Geiger Counter general information and code.
Alternative way of interfacing the NETIO GC10 geiger counter
In the past can provided a solution to interface the GC10 geiger counter to a PC by a serial connection.
The problem to overcome was that the GC10 serial interface uses positive 5 Volt signal…