The Playground
-
-
The setup is in France, controlled in remote from the USA,
Warm Regards, A.R.
LOL. How many hours until this statement is shown to be a lie?0.25 hours ...kudos to h_l !
-
-
Quote
Andrea Rossi
March 20, 2023 at 5:26 AMCC:
The EMF sensor is: SMART SENSOR EMF-TESTER AS 1392
The Radiations sensor is: GEIGER GEEWORKS- NUCLEAR RADIATIONS DETECTOR
Both bought by Amazon
Warm Regards,
A.R.
Both cheapest you can get.
-
Both cheapest you can get.
Good. Obtainable by almost anyone.
It is not horrifically expensive to equip one’s laboratory to the standard of Rossi.The Stellar Net spectrometer is probably his most expensive purchase.
He should point it at the light!
-
Here is a screenshot from when he held one of the meters in front of the camera. We see a mirror image of the webcam (the black thing down below), Rossi, and most interestingly a light on the wall that pretty much looks like the light from the SKLed.
For comparison:
The direction of the light however doesn't contribute to the external light theory. It almost looks like it's actually coming from the SKLep-lamp.
-
Here is a screenshot from when he held one of the meters in front of the camera. We see a mirror image of the webcam (the black thing down below), Rossi, and most interestingly a light on the wall that pretty much looks like the light from the SKLed.
For comparison:
The direction of the light however doesn't contribute to the external light theory. It almost looks like it's actually coming from the SKLep-lamp.
nice capture!
Actually, since the reflection of the front cam is immediately ahead, we can see someone's head (AR, minus wig & wearing glasses?) slightly to the left, and it is clear that he is lit from further left, causing illumination on a surface slightly to the right
If that light were from the demo lamp he (and the camera) should be lit more full-on
-
Sam! Glad you are back on the Rossi thread. What do you think of His latest magnificence? Are you still more or less convinced He is for real? What do you make of the latest JONP postings from "Yuri", who, with his team, brilliantly calculated the luminance output at over 2W just from the webcam? Do you think it was strange that the post was attributed to Rossi in the HTML? Last time I heard from you on the subject, about 4 years ago, you were going to give the Esteemed Dr. Rossi, Supreme Leader, the benefit of a doubt for a few more weeks.
-
What ever time it takes to find out one way or the other.
Just like the skeptics I have to keep
plug-in away.
I suppose I should be concerned about Yuri comment but I am not.
-
-
-
Also a red cone put over the front of a SKled...
.
-
Also, note how the Saran Wrap(TM) or equivalent placed over the lens makes the lens glow a bit.
.
-
Also a red cone put over the front of a SKled...
.
Good catch!
If this is the culprit providing the 'extra' lighting of the demo lamp, it would make sense of a white beam in the main forward direction ...and maybe a certain red glow seen from other angles nearby?
LOL ...you know it's JUST possible that this was also used to augment the apparent light output of the 'grid-based' demo too!
Remember the infamous 'consume' test on the prev demo streaming of the grid-based SKLep?
The meter is connected between the lamp and PSU - the lamp dims to seemingly zero-illumination - the 'team' proudly proclaim some low current (on a meter with a broken display, no less!)
And there - down on the desk, to the left of the meter stand - is a patch of bright white light that shouldn't be there! The lamp is basically off (only reflecting ceiling light)
Looks to me about right for the anomalous lighting gradient location shown as a digitised photo earlier
-
Unless someone in the 'team' has a fetish for cardboard boxes, the far setup (showing old lamp + PSU) looks VERY much like the setting for the new demo lamp...
In photo of new lamp, in its demo setting, attached here:-
The laptop is on a high wooden table/desk
The front cam is on small tripod on 1 box
in front of demo lamp is pile of 3 boxes
the wall is near right-hand of demo table, as and when seen from front cam
....this would be the wall that we see illuminated in the EM/GEIGER test reflection (shown by h_l earlier)
the pile of boxes is probably being used there now to support the SKLed + red tube
the old PSU will be providing power to the SKLed, with the red digital displays adding to the red reflections (as guessed earlier by h_l)
-
Also, note how the Saran Wrap(TM) or equivalent placed over the lens makes the lens glow a bit.
.
Yep, already noted earlier 👍
-
One of those cardboard boxes says "Xenon HID". Maybe a leftover from his first SKLep demo with all that electronics junk and an opened Xenon ballast. The same boxes can be found at Aliexpress.
Here is a generic standard headlight looking pretty much exactly like the one in the demo:
It's probably a coincidence, but right across the street from the "lab" there is a motorbike shop named "Magazzini Rossi" where one could get all that stuff.
-
-
EXIF Spoofing is child's play.
Can EXIF Data Be Changed or Faked? - Your Photo AdvisorMany people don’t know this, but the EXIF data that is included with an image contains lots of information on location, date, camera type, and much more. EXIFyourphotoadvisor.com -
he's just claimed that this 'lab' setup is in France - too lazy to spoof EXIF to support this?
Want to Advertise or Sponsor LENR Forum?
CLICK HERE to contact us.
CLICK HERE to contact us.